Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Missing Drill files in Allegro

Status
Not open for further replies.
saumya_85

saumya_85

Advanced Member level 4
Joined
Mar 18, 2009
Messages
107
Helped
6
Reputation
12
Reaction score
5
Trophy points
1,298
Location
INDIA
Activity points
1,948
While creating Gerber file & NC drill file, I am missing drill hole in output.

What is the procedure for that ? Anybody help me out !
 

-You have to Generate the NC drill files.
-If even it is missing than check the Padstack for that drill.
 

whether your drill table reads the correct data?
in NCDRILL parameters tick
leading zero suppression
equal coordinate suppression
enhanced excellon format
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top