Minimum Solder Mask Sliver Altium

[chuck93]

Hi,

I get this error running the Design Rule Check in Altium Designer:

Minimum Solder Mask Sliver (Gap=10mil) (All),(All)

The error is between the pads of a controller from an altium library.
How can I disable this error? Is there any rule to define for this error?

Thanks for your help

 

[FvM]

Is there any rule to define for this error?

Yes, as expectable, you'll find it under rules. Rather than disabling it, you'll want to set it to a reasonable value according to your PCB manufacturer design rules, e.g. 4 mils/0.1 mm.