Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

microwave studio and multiple processors

Status
Not open for further replies.

cross

Member level 4
Joined
Dec 31, 1999
Messages
72
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
509
If I'm not mistaken cst studio can utilize more than one processors. Anybody knows if it can use processors of different machines or is it a case where it can use two processors on a single motherboard?

Rgds

Cross
 

vanderspunk

Junior Member level 2
Joined
Dec 31, 1999
Messages
23
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,283
Location
Sweden
Activity points
135
It can only use two processors on a single motherboard.
 

aw

Member level 3
Joined
Jun 9, 2001
Messages
54
Helped
5
Reputation
10
Reaction score
3
Trophy points
1,288
Activity points
333
processors

are you sure about this Vanderspunk because I'm not !? MW$ can handle apparently up to 32 processors on a single sysem - problem is finding a board with more than the usual 2 processors and at a reasonable price! If Parallelisation is possible for 2 processors then it's scaleable for any number depending on what the system allows......
 

vanderspunk

Junior Member level 2
Joined
Dec 31, 1999
Messages
23
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,283
Location
Sweden
Activity points
135
No aw, I'm not fully sure. I've only tested mwStudio on a dual processor system.
But according to hxxp://www.cst.de/products/mws/technical/technical.htm :
Multi-processor support (parallel version for two processors on one main board, only for transient and eigenmode solver)

But next version (later this year?) is supposed to have support for multiple computers (over network), from what I've heard. Can someone confirm this? Don't know how they are going to charge their customers for this option.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top