Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Microwave office design / impedance matching

Status
Not open for further replies.
I

ifeanyibaba

Newbie level 2
Joined
Apr 19, 2009
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,295
microwave office impedance matching

Please i need help on how to go about this?
1. I want to modulate a GUUU device with a signal from a microwave signal generator and there is a fairly long 50ohm cable between them.The frequency range is 500MHz to 10GHZ.
2. What kind of matching would i use to maintain the same amplitude on different range of frequencies..

Thank you
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top