Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Microwave/MMIC INTERVIEW Question

Status
Not open for further replies.

Puppet1

Advanced Member level 2
Joined
May 7, 2004
Messages
689
Helped
11
Reputation
22
Reaction score
9
Trophy points
1,298
Activity points
6,074
Assume a device can be represented by the transmission line network.
We measure with a network analyzer calibrated to 50 ohm reference impedance.

-------------------(line length = 15mm, Zo=30ohms)---------(load = ZL = ?)


S11-------------->
0.4(154 degrees) @ f=3GHz
(S11 looking into this network)

What is the complex load impedance at 3GHz if device under test consists of 15mm section of microstrip transmission line whose characteristic impedance and effective dielectric constant are 30ohms and 6.7 respectively, at frequency of interest.

A) assume microstrip is lossless
B) then assume loss factor 1dB/cm at 3GHz

Answers to this problem welcome !
 

no i am not offering a job.

people keep asking for interview questions, so i posted one.

if you answer it i will be impressed.
 

hey thanks for the question..keep posting more..it helps

useless!!! warning 2

--eirp
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top