Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Microwave Doppler radar Sensor used for car detection

Status
Not open for further replies.

lavricalex

Newbie level 3
Newbie level 3
Joined
Nov 14, 2011
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,305
In my project I want to use a Doppler radar Sensor in order to detect the presence of a car.
So I bought from e-bay the sensor.

**broken link removed**

I connected to the IF output the attached circuit figure (2 X LM324).

Using an oscilloscope at the output i have a 4 V signal which has a frequency of about 50 Hz and when i have movement the frequency shifts to 20 Hz.

My question what circuit i need to connect this sensor to a microcontroller (ADC, DAC inputs) in order to know when a detection occurs.

Best regards,
Alex
 

Attachments

  • circuit.jpg
    circuit.jpg
    38.3 KB · Views: 108

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top