Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronic Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Microwave Amplifier Design

Status
Not open for further replies.

kyawmyatthu

Newbie level 4
Joined
Sep 7, 2006
Messages
6
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,314
Pls,

I want to design two-port amp.

Tx of 1mW at port 1 is amplified to 1 W at port 2.
Rx is supplied at port 2 and amplified to 40dB at port 1 with less noise.
Freq 1.8 to 2 GHz
Ref Impedance 50 ohm
Supply Volt 3 V.

I need reference to design above specification.

Pls advice .
Thanks
 

zeshan102

Advanced Member level 4
Joined
May 31, 2003
Messages
100
Helped
11
Reputation
22
Reaction score
8
Trophy points
1,298
Location
Heart of Pakistan
Activity points
643
u can design it using multistage amp for front stage use mini circuit mmic amp and in final stage use hittite HMC453ST89 but i think u will require at least 5v power supply

Regards
 

kyawmyatthu

Newbie level 4
Joined
Sep 7, 2006
Messages
6
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,314
Thanks,

If u know any reference for amp design,pls share me.Let me know web sites too.

KMT
 

Status
Not open for further replies.
Toggle Sidebar

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top