Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

microstepping using SLA 7062

Status
Not open for further replies.

pyl_pankaj

Newbie level 1
Joined
Dec 23, 2006
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,287
sla7062

i'm using SLA7062 for stepper motor(3 A/phase), when i'm increasing current above 0.5 A motor will stop and below 0.5 A it is running, i'm using 1E current sense resistor.

tell me what may be the problem
 

edison

Newbie level 4
Joined
Aug 5, 2005
Messages
6
Helped
1
Reputation
2
Reaction score
0
Trophy points
1,281
Activity points
1,331
sla 7062

According to the datasheet you may be having a problem with your Vref. What is your reference voltage on pin 7?

Also, I use two 0.3 ohm, 3W, 1% sense resistors. These have a lower heat dissipation than 1 ohm and result in a Vref of 1.0 volt for 3 Amps of motor current.

LNS Technologies www.techkits.com/industrial
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top