[SOLVED] MicroC SPI Ethernet Library problem

[dim912]

I am using the PIC MINI WEB header board which includes PIC18F25J10 and ENC28J60 Ethernet controller. the program for the header board is written on MicroC.

When I use the SPI Ethernet library many of input output pins of the PIC do not correctly works. But When I do not use SPI Ethernet library and program the
header board, those pins correctly works.

Ex : I can use A0, C0,C1,C2 pins to drive LEDs as my wish when I do not use SPI Ethernet library. But When I use the SPI Ethernet library, LEDs connected to
those pins never get on.

But I want to use both SPI Ethernet library and other general input output pins of the header board.

If you have any suggestions and similar experiences, please help me.

 

[bigdogguru]

You'll need to post or upload your code, so that one of us can take a look at it.

BigDog

 

[dim912]

Hey I found the fault I have done.
It is not in the code :razz:

mistakenly I have not disconnect ICSP programmer from the header board when I run the program.
The program correctly runs with expected results, when the PIC is running after disconnecting the ICSP programmer from the board.

Thank you for your kind heart Mr.bigdogguru.