Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Micro SD Card Controller Using SD 1 Bit Mode

Status
Not open for further replies.
S

santhu456

Newbie level 3
Joined
Mar 14, 2013
Messages
4
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,307
FvM said:
I don't understand your question. PATA interface means hard disk data storage, no flash would be used then.
Click to expand...


Hi ,,,
I am developing Micro SD Card Controller,,, One side Using SD 1 bit mode interface and other side Avalon interface...

From Avalon interface we are getting address and control signals as inputs,,, address represents what? how can i map that in to sd memory card memory location???

I have a doubts like by using CSD register parameter values we can find out how many sectors, capacity of card and block length,,, but how many blocks are present?? and how can we know the address of each block while reading or writing from/into the memory card???

please help on this????

Thank you... :)
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top