cupoftea
Advanced Member level 5
We have three low voltage, SMD, Buck converters for overall 12W that we want to shield (block radiated emissions) with the following through hole metal PCB shield.
BMI-S-205-F and BMI-S-205-C. (on page 11 of the following.....)
https://www.laird.com/sites/default/files/board-level-shields-catalog-download.pdf
Does the Frame bit have to be soldered in to the PCB ?(ie presumably the PCB slots are plated through for soldering purposes?
Also, regarding the PCB shield.....
(BMI-S-205-F and BMI-S-205-C).....is there any reason that our mechanical engineer can't copy these, so that we can make our own?
BMI-S-205-F and BMI-S-205-C. (on page 11 of the following.....)
https://www.laird.com/sites/default/files/board-level-shields-catalog-download.pdf
Does the Frame bit have to be soldered in to the PCB ?(ie presumably the PCB slots are plated through for soldering purposes?
Also, regarding the PCB shield.....
(BMI-S-205-F and BMI-S-205-C).....is there any reason that our mechanical engineer can't copy these, so that we can make our own?