Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
You are talking about stencil for Paste Mask. Depending on board design and type of soldering or assembly processes, PM stencil is made of different thickness 4, 5, 6, mils for example.
In Allegro there are many ways to create Paste Mask layer easiest one is to use at component level when you are making your Footprints. Or you can add at board level but is not a recommended practice.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
