Mentor Expedition PCB

[purva123]

I am looking forward to use Expedition PCB. I have some queries:
1. How to assign clearances in net class?
2. How to assign nets to net classes?
3. How to specify net class trace width in expedition?
4. whenever we transfer design from schematics to expedition PCB , only one sheet i.e. working sheet gets transferred. So how to transfer whole design in one attempt?
5. How to swap pins and gates manually?
Reply soon as soon possible.:shock::shock:

 

[sivamani]

use Constraint manager for constraints

 

[purva123]

use Constraint manager for constraints

for which point, this answer is?

 

[sivamani]

1.How to assign clearances in net class?
2. How to assign nets to net classes?
3. How to specify net class trace width in expedition?

 

[purva123]

1.How to assign clearances in net class?
2. How to assign nets to net classes?
3. How to specify net class trace width in expedition?

Can you please give the steps?

 

[sivamani]

I have used 8 years back and now i don't have clear step by step procedure..please use cis help..

 

[senilicus]

You can find all the necessary information in the Constraint Editor System 9CES) user manual. If you have a valid Mentor installation you can find the manual at "C:\MentorGraphics\7.9.4EE\7.9.4EE\docs\pdfdocs\ces_user.pdf".
You can also login at supportnet and find the manual there.

If you don't have a supportnet login, you can register at https://www.mentor.com/support. You need a site id to register.