Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Mentor Calibre Mixed-Signal Bulk ISSUE

Status
Not open for further replies.

cheneyliu99

Newbie level 3
Joined
Jul 2, 2009
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,303
Hi All,

I am designing a mixed-signal chip. In my schematic, I used different pins for different signal's bulks. e.g. ASUBGND for analog bulk, PWR_SUBGND for Power circuit bulk, etc. When I do Calibre LVS, whenever I have types of signals, LVS will not let me pass. The reason is that, physically, all these pins share save p-substrate layer.

Is there any way that I can pass the LVS without too much modification. e.g. adding some rule file for LVS saying that ASUBGND equals to PWR_SUBGND etc.?

Or do I have to modify the schematic?
Thanks!
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top