Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Measuring DC offset and DC superimposed voltages , whats the difference

Status
Not open for further replies.

danny davis

Banned
Joined
Mar 1, 2013
Messages
627
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,296
Location
Hollywood
Activity points
0
Do you measure DC offset from the Negative Peak cycle of a sine waveform or do you measure the DC offset from the zero crossing points of the sine wave cycle?

If you have a 6VDC offset, is the measurement from the Oscilloscope's zero Origin zero volts to the negative peak of the AC sinewave or to the zero crossing point of the AC sinewave?

When measuring AC ripple on a power supply is the measurement from the Oscilloscope's zero Origin zero volts to the negative peak of the AC sinewave or to the zero crossing point of the AC sinewave?

DC superimposed on a AC waveform is different than DC offset voltage?

DC superimposed voltage means you measure the DC voltage from the zero origin to the negative peak of the cycle?

Whats the difference between DC superimposed voltages VS DC offset voltages?
 

you measure the DC offset to the zero crossing points of the sine wave cycle

the zero crossing point of the AC sinewave is sitting at 6V on your CRO.

When measuring AC ripple on a power supply is the measurement from the Oscilloscope's zero Origin zero volts to the negative peak of the AC sinewave or to the zero crossing point of the AC sinewave? Neither, its the peak to peak voltage of the superimposed ripple waveform.

DC superimposed on a AC waveform is different than DC offset voltage? Just semantics, offset voltages normally refer to odd voltages at the input of opamps. DC superimposed on a AC waveform, would mean that some DC is added to a signal wave form for some purpose.

DC superimposed voltage means you measure the DC voltage from the zero origin to the negative peak of the cycle? no it is the zero crossing thing again.

Whats the difference between DC superimposed voltages VS DC offset voltages? see previous answer.
Frank
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top