Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

measuring 3 phase voltage directly with a pic adc

Status
Not open for further replies.

joshinjoy

Newbie level 1
Newbie level 1
Joined
Apr 16, 2010
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
india
Activity points
1,288
Please Some body help

For my new project i need to measure the 3 phase voltage. and implement high voltage cut off and low voltage cut off
ie; high voltage cutoff at 440v and low voltage at 380v
i need it to do with a pic16f877 controller. i don't not know any thing about 3 phase
what i need is a circuit.

thanks in advance
 

Investigate if the 3-phase system has Neutral ..
If yes, the voltage of each phase referenced to N is roughly 230Vac and you can use off-the-shelf mini-transformers to reduce that voltage to, say 9Vac ..
From here follow the attached circuit ..

:wink:
IanP
 

Attachments

  • AC-to-PIC---inputcircuit1.png
    AC-to-PIC---inputcircuit1.png
    3.7 KB · Views: 180

Investigate if the 3-phase system has Neutral ..
If yes, the voltage of each phase referenced to N is roughly 230Vac and you can use off-the-shelf mini-transformers to reduce that voltage to, say 9Vac ..
From here follow the attached circuit ..

:wink:
IanP



Dear Sir I am also facing same problems but i converted 230 volts into 5 volts using step down transformer on each phace but when i conected one phase voltage to pic circuit bord that phase voltage shows correct ADC results but other than this conneted pic chip phase its shows a abnormal voltages like 0, 5 volts fluctions i using ADCON1 registors for refrence voltages by selecting multiplexer its not working properly, but i still struggling plese guide me how to maintain contant voltage on each phase and
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top