rajbabu
Junior Member level 3
Hi,
I am using MB1010 LV-MaxSonar®-EZ1™ sensor for distance measurement. It gives analog output according to distance. When I am using stand alone than output comes but when i connect its analog output to microcontroller adc input then suddenly it goes in high state. Their is no pull at this pin I am using PIC16F877a AN0.
Anybody knows why this is happening.
Rajbabu
:?:
I am using MB1010 LV-MaxSonar®-EZ1™ sensor for distance measurement. It gives analog output according to distance. When I am using stand alone than output comes but when i connect its analog output to microcontroller adc input then suddenly it goes in high state. Their is no pull at this pin I am using PIC16F877a AN0.
Anybody knows why this is happening.
Rajbabu
:?: