Welcome to our site! EDAboard.com is an international Electronic Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
As a strict upper limit, it must be the number of paths in the design, right? For a practical limit, it must be tool dependent. I imagine for a modern tool, it's pretty large, but I'm afraid I can't answer better than that. Have you hit this limit? If so, what was it and for which tool?