pkedvessy
Member level 5
Hy all!
I tried to drive this device from the datasheet, but I have some problem...
In no decode mode, it is working until I tried to set 4 segment on any digit! After I tried to set the 5th digit, all start to blink...
The Vcc current is about 800mA, so it should be enought!
Thanks
I tried to drive this device from the datasheet, but I have some problem...
In no decode mode, it is working until I tried to set 4 segment on any digit! After I tried to set the 5th digit, all start to blink...
The Vcc current is about 800mA, so it should be enought!
Thanks