Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hi,
I am using CCS 3.1 and the matlab R-2010a student version. the above link supports for matlab R-2013 only..
I want an comptability for this student version. is it possible??
Matlab R-2013 doesn't exist yet ...... Why you don't try it? if you have Matlab and CCS ......
Differences in Student Version
The Simulink in Student Version provides the full functionality of the professional version of Simulink, with the following differences:
Models (including the blocks in referenced models) are limited to 1000 blocks.
Accelerator and Rapid-Accelerator simulation modes are not available in Student Version.
Model blocks can be used in Normal mode only.
Ok fine.See,I am using R2010a(student version). when i need to interface with DSP processor (tms320c6713), should i have CCS 3.3?
I tried with ccs 3.1, but its not supporting...., simulink model shows an error like,
Embedded IDE link should be interfaced with ccs3.3 only...
then, what to do to solve this problem?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
