Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Cut required portion of 0.5inch Plywood and lay on the working place which will act as an insulator, which is also harder than ceramic, and will also resist heat to some extent from the molten solder and the Iron. If you work on daily basis, the wood will last for abt 7-8 years. Goodluck
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.