Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Marx Generator - „hydraulic installation”

Status
Not open for further replies.
V

Vermes

Advanced Member level 4
Joined
Aug 2, 2011
Messages
1,163
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,316
Activity points
22,318


Construction of this Marx generator is very simple. „Scaffolding” was made of the PVC pipes. Capacitors were made of pool foil and also PVC pipes, flooded with transformer oil. They withstand 40kV without oil, while with oil it is up to 90kV, while powered from 10kV. 6 degrees are available. Currently, you can get the lightning of about 7cm of rather „fat” thunder (about 3mm) and about 12cm at very stretched and in good conditions.
Typical power of the inverter based on TV transformer.



Link to original thread (useful attachment) – Generator Marxa - "instalacja hydrauliczna"
 

Do you have any video from this in operation?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top