Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Making your ICD2 With USB Full Speed !

Status
Not open for further replies.
full speed icd2

does this version work with a dsPIC and is debug mode suported as well?

gr sander
 

icd2 full speed

Does you make the offset film with the cypress CY7C64613-52NC?
 

Hi,
No, this design ICD2 is for cypress CY7C64613-80NC only !
(for the CY7C64613-52NC, remake a new board !)
Why ?
the cypress CY7C64613-52NC is not find in france !
for the dspic, i don't know...
Patrick
 

Hi,
does anyone know whats the component "FU1" should be? Is it a fuse or other else... Thank you!!
 

Hi,
FU1 is a small Fuse (500mA is Ok)
Usage: protect your USB port
Best Regards,
Patrick
 

hi,
there is no firmware file for CY7C64613 - it is uploaded via USB every time when you connect ICD2. you have to write only corect VID&PID values in eeprom connected to CY7C64613. bin contents of the eeprom may be found in this forum - use search link if you need this

best regards,
stroma
 

Hi,
I point out that this clone work fine, and that the cy7c64613-80nc is available here: www.radiospares.com (ref: 444-6472 ) :D
Patrick
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top