Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Making custom gears & Hardness

Status
Not open for further replies.

MathGeek

Member level 3
Joined
Aug 16, 2005
Messages
67
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Activity points
1,806
I have a little robotics project that I will get working on (if I get everything right).

I want to creat custom gears for experimenting. Small gears are hard to purchase in variety of sizes.

One method that draw my attention is liquid plastic. But hardness is my question.

Is 80 on "Shore D scale" comparable to generic nylon gears?
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top