Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

LTC 2440 Interfacing : Help!

Status
Not open for further replies.
E

ex4

Full Member level 2
Joined
Dec 28, 2004
Messages
120
Helped
2
Reputation
4
Reaction score
1
Trophy points
1,298
Location
Jakarta, Indonesia
Activity points
958
ltc2440

I've got 24bit ADC chip LTC2440 from Linear in 16 pin SSOP pckage. After reading the datasheet, i build the circuit with ATMEGA16 and SHIFTIN to get the data. But I got strange data and it's not represent the data expected?
ANybody can gave me some advice?
 

If you could put up the schematic, it would be easier to answer.
Giri
 

chek the reference voltages, may be they are not correct
 

This is the circuits. CS I held low (grounded), SDI I held high (VCC), So I need only to poll the SDO pin and wait it to go low
 

according to the PDF, the reference voltage is from 0,1V - VCC so it doesn't makes a matter :D
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top