Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Lt8302 not working on load

Status
Not open for further replies.

Arpit Gupta

Junior Member level 2
Joined
Jun 10, 2015
Messages
22
Helped
2
Reputation
4
Reaction score
2
Trophy points
3
Activity points
164
THE LT8302 FLYBACK CONVERTER that i designed is not working on load
it was designed for 3 multiple outputs of 12 v
ON no load the all the output shows 13.24 V
But as soon as even at very low loads of milliAmps the voltage disappears

what could be the reason?
 

D.A.(Tony)Stewart

Advanced Member level 5
Joined
Sep 26, 2007
Messages
7,078
Helped
1,724
Reputation
3,447
Reaction score
1,729
Trophy points
1,413
Location
Richmond Hill, ON, Canada
Activity points
51,937
Most likely layout problems of line inductance, high ESR secondary caps or lack of attention to details.

"the basics of current mode DC/DC conversion will not be discussed here; instead, the reader is referred to the detailed treatment in Application Note 19, or in texts such as Abraham Pressman’s Switching Power Supply Design"
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top