Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Low pass filter in SCILAB/MATLAB

Status
Not open for further replies.

aryajur

Advanced Member level 3
Joined
Oct 23, 2004
Messages
793
Helped
124
Reputation
248
Reaction score
37
Trophy points
1,308
Location
San Jose, USA
Activity points
7,788
Hello,
I have a signal vector and I wanted to low pass filter it. My knowledge of discrete filters is very limited so any help would be greatly appreciated.
My signal is basically a sampled instance of a sum of sinusoids of 100Hz and 1KHz. What I want to do is basically filter this sampled signal so that I am just left with the 100Hz signal and then plot the resulting signal.
So basically I just need a low pass filter with a cut off frequency of 200Hz and large attenuation at say 800Hz and beyond.
Any leads, help would be appreciated.

Thanks.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top