Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Looking for the schematic of one wire LCD interface

Status
Not open for further replies.

astroman132003

Junior Member level 1
Joined
Oct 14, 2003
Messages
16
Helped
2
Reputation
4
Reaction score
1
Trophy points
1,283
Location
Portugal
Activity points
97
i-wire lcd interface

i need the schematic of one wire LCD interface
 

1 wire lcd interface

If I understand this issue correctly you would like to build a circuit that converts multipin LCD display into 1-wire control. The easiest solution will be to employ a microcontroller and use its UART RX input to receive data.
An example of this you can find here:

http://www.terra.es/personal8/japus12/stermunit.html
 

Re: LCD interface

here is one from scott edwards
 

Re: LCD interface

IanP said:
If I understand this issue correctly you would like to build a circuit that converts multipin LCD display into 1-wire control. The easiest solution will be to employ a microcontroller and use its UART RX input to receive data.
An example of this you can find here:

h**p://www.terra.es/personal8/japus12/stermunit.html

the link is forbidden by my school, i cannot access...
dunno whether everyone else can access it?
 

Re: LCD interface

I don't quite understand the meaning of -

[...converts multipin LCD display into 1-wire control. ]

Does it means that we can control a LCD module with just a single pin? I have access the the web site refered to and saw the schematic. It seems to me that all it does is that the io pins is shared between the keypad and LCD module. It still uses 4 data pins to transfer data to the LCD module. And I presume the LCD Enable is use for the sharing purpose.

rgds,
chicken_feet
 

Re: LCD interface

I want to build a LCVD interface with a 74LS164 shift register..

Someone it have a PIC CCS C routine to control this device???
to change the lcd.c driver file???

I have a asm routine, but i want a C routine...


Thank you to all?
 

LCD interface

The connection can be done by 2-wires for min
By using Shift register and 4-bit mode I'll can sen you the full schecamatic later
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top