Most electret mic preamp circuits are similar. Maybe a more expensive opamp can be used for less hiss.do you know any other good preamp for Electret MICs(half duplex)?
A digital teleconference system does not have the 4-wire-to 2-wire converter used for a telephone line so the only feedback will be long distance feedback. A half-duplex circuit is separate from a mic preamp. Motorola (Freescale) make some half duplex speakerphone ICs that work better than most cheap speakerphones. I made a pretty good voice-switching speakerphone with a Motorola IC about 29 years ago.I am using ready-made DM368 processor based board, which have audio input & output port. I want to use audio in (MIC) for conference.
My preamp circuit has a gain of 215 times when the 470k trimpot is turned to maximum. That is plenty of gain. If you want more gain then increase the 470k to 2.2M and/or reduce the 2.2k to 470 ohms. With more gain then you will have more background noise and more electronic noise. Two preamps each with a gain of 215 times makes a total gain of 46,225 times which is stupid.I was asking, if I use same two preamp ckt(based on TL071) i.e. output of one preamp connect input to another preamp. I think noise more boost up as compare to signal.
The preamp cannot drive an impedance less than 10000 ohms. But a speaker is only 8 ohms so it must be driven by a power amplifier. The preamp drives the power amplifier.When I am using this preamp ckt with PC (giving external 9V) for audio recording, Its able to record high quality audio. Why different behavior with speaker?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?