serenade + rf design
Thanks Khouly for the details. However I am facing various problems which simulation the same on serenade.
First of all I am unable to find the open circuit stub in serenade, which needs W and P as input, i found one which asks for Z and P as input.
Secondly, in transmission lines wat should be label. I left default 'sub' thr but while analysis it was giving problem.
Thirdly, in the 2 port a gave device name as 'at31011' but what should be the file. In the figure its shown at31011.s2p but I dont have any such file. Also further there are other parameteres i need to fill in the 2 port table. Can someone tell me the details for the same.
I know I am unale to do anything [
] but kindly help me through.
Regards,
Abhinav
Added after 1 minutes:
If not a problem can someone kindly send me a serenade simulation file of the schematic I have posted. I can build my further schematics taking your simulation file as the base.
Thankx in advance,
Abhinav
Added after 8 minutes:
Similarly I am trying to simulate example 4, on page number 9 of the following file:
**broken link removed**
thr again in the 2 port device, thr we can see device as FET11_3 and file px11_3.flp. Now where to put the .flp file. However in the document the content of the .flp file is also given.
Kindly help me in any one of the simulations. Any one simulation will be enough for me.
Regards,
Abhinav