vege420
Newbie
Hi everyone
So I'm planning to make an amplifier circuit, like shown in the picture attached.
Except I want to add an audio output, so I can e.g. record the signal that goes to the speaker. How should I go about this? Where should I mount the 6,3 mm jack?
Also, can somebody proofread this diagram for me? I'm a total noob.
I won't install the LED and resistor though, if that's important.
Thanks in advance.
So I'm planning to make an amplifier circuit, like shown in the picture attached.
Except I want to add an audio output, so I can e.g. record the signal that goes to the speaker. How should I go about this? Where should I mount the 6,3 mm jack?
Also, can somebody proofread this diagram for me? I'm a total noob.
I won't install the LED and resistor though, if that's important.
Thanks in advance.