LM2676 Buck converter Schematic and PCb design in Eagle.

[adnan012]

hi,

I have designed a PCB for lm2676 buck convert in Eagle . I want to know that is there any issue regarding nets, via , silk etc. the design files are attached. I have experience in Orcad16 but i have to design small board in Eagle.

 

[Kick]

ur circuit and design are very good.In silk the main thing u have to care about is overlapping,I think in ur design its not there.so dont worry

 

[adnan012]

Thanks for reply.
How GERBER files are generated in eagle ? How via drill are defined?

 

[Kick]

In eagle there will be 13 files for 2 layer board and 15 files for 4 layer board.There is one step by step process to generate GERBER,I will try to send it today

 

[adnan012]

Kindly generate the GERBER files.

 

[Kick]

follow this steps

1.ulp>drillcfg.ulp>open.

2.CAM>File>open>job>gerb274x>process job.(gerb274x-4layer-for 4layer)

3.CAM>File>open>job>excellon>process job.

4.ulp>drilllegend.ulp.

5.Enable 20&144 layer in board and generate pdf file.

6.ulp>picknplace.ulp

now u will have 13 files for 2 layer board,just zip all files...that' all