neddie
Full Member level 5
- Joined
- Feb 23, 2010
- Messages
- 251
- Helped
- 41
- Reputation
- 82
- Reaction score
- 35
- Trophy points
- 1,308
- Location
- South Africa
- Activity points
- 3,026
Hi to all.
I'm trying to get an LIS3DH accelerometer working and I have a question about the output data.
It seems to be very "noisy". I have the board with the accelerometer on a flat table.
I've set the data rate to 100hz and 2g fullscale , high res mode on.
The data seems to jump all over the place. If I tilt the board fully one direction I get about 16000 counts
and fully the other direction I get about -16000 counts, which seems to be about right.Still very noisy
around the main reading.
when it is flat on the table I get anywhere from +128 to - 128 counts. Counts change in increments of 16.
Is this normal behavior?
Cheers
Neddie
I'm trying to get an LIS3DH accelerometer working and I have a question about the output data.
It seems to be very "noisy". I have the board with the accelerometer on a flat table.
I've set the data rate to 100hz and 2g fullscale , high res mode on.
The data seems to jump all over the place. If I tilt the board fully one direction I get about 16000 counts
and fully the other direction I get about -16000 counts, which seems to be about right.Still very noisy
around the main reading.
when it is flat on the table I get anywhere from +128 to - 128 counts. Counts change in increments of 16.
Is this normal behavior?
Cheers
Neddie
