Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

LCD timer code needed MikroC

Status
Not open for further replies.

ahonda55

Newbie level 3
Joined
May 31, 2012
Messages
4
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,313
Hello, I am building a timer which produced a pulse after a desired time, the time fractions are in milliseconds, and i need to show the desired timer setting on a standerd LCD.
it should start from 0.1..0.2..0.3......0.9..1.1..........5.0
from 0.1sec to 5 seconds.
I just need a code to increase a number by 0.1 to reach 5.0, then show the number on the LCD. That's all :)

Any help is apreciated a million :D
Thanks in advance.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top