giorgi3092
Junior Member level 2
Hi,
I am designing a mixer in ADS and using mixer design guide, available in ADS to set up the testbench. In particular, I am using this template:
In data view, it has a lot of equations to calculate all sorts of things like gain, impedances, spectra, etc.
I am interested in optimizing my design for down conversion gain as shown below:
However, in the schematic window, in a "Goal" component, how do I ask ADS to optimize for this variable - "ConvGain_Dwn" ?
It seems ADS simply does not allow this? Unless, I missed something.
I tried copying over the relevant equations into the schematic in a "var" component, but then it complains that "mix()" function does not exist.
Is this possible to do or I'm out of luck?
I am designing a mixer in ADS and using mixer design guide, available in ADS to set up the testbench. In particular, I am using this template:
In data view, it has a lot of equations to calculate all sorts of things like gain, impedances, spectra, etc.
I am interested in optimizing my design for down conversion gain as shown below:
However, in the schematic window, in a "Goal" component, how do I ask ADS to optimize for this variable - "ConvGain_Dwn" ?
It seems ADS simply does not allow this? Unless, I missed something.
I tried copying over the relevant equations into the schematic in a "var" component, but then it complains that "mix()" function does not exist.
Is this possible to do or I'm out of luck?