Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Isolated half bridge driver

Status
Not open for further replies.
A

Arpit Gupta

Junior Member level 2
Junior Member level 2
Joined
Jun 10, 2015
Messages
22
Helped
2
Reputation
4
Reaction score
2
Trophy points
3
Activity points
164
Need a isolated half bridge driver to drive the mosfet CSD19535KCS from TI.
I had selected lm5106 as the gate driver earlier as i need 100V bootstrap voltage but it would be better if i get an isolated driver.?
 

Hi,

i need 100V bootstrap voltage
Click to expand...
Bootstrap voltage usually is about 12V. But when bridge output is HIGH, then this voltgae is shifted up on bridge_voltage.

***
Usually the isolation is on the input side of the gate driver, so it has nothing to to with botstrap circuit...

A schematic could help.

Klaus
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top