is there anyone know how to install IC5141 on fedora 4

[equantum]

install ic5141 on fedora

could u kindly tell me how to install it?? thanks!!!

 

[jelydonut]

run ./SETUP.SH off of CDROM1 to install..

then you just need to set up your env variables for..

paths..

/tools/bin
/tools/dfII/bin
/tools/dracula/bin

install dir is $CDSDIR

and stick your license in.. /share/license

jelydonut

 

[equantum]

thanks...

 

[justin.li]

Have you install it yet? WorK ok?

 

[haoshs]

I have installed IC5141 on the FC4, and it works well.
To installed it, you need change the tar program to the before version. than you just follow the install guides.

 

[sean202]

Dear Haoshs,
Where is the tar program? file name? Is it 'tar-1.xx...rpm'?
How to replace the tar program with old version?
Need your advice. Thanks a lot.

 

[haoshs]

It's 'tar-1.3.x...rpm' or 'tar-1.4.x...rpm'.
You can get it in the redhat9.0 or others

 

[neo79]

Hi haoshs,

How did you uninstall the original tar program in FC4?

when i used rpm -e tar, it is said "dependency.... blah blah.... " and can not uninstall it.

Could you help on this?

thanks.

Added after 11 minutes:

sorry for my stupidi, i have successfull remove it using simple command.

 

[haoshs]

you need add --nodeps option, as following:
rpm -e tar-1.5.1 --nodeps
good luck!

 

[edacw1]

why not install RHEL3 for IC5141? RHEL3 is better than FC4 for EDAtools.

 

[wasm]

Use Centos 4.3 better if without updating to 4.4

I think that for ic610 you have no problem also with CENTOS 4.4