Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Is there a way to print model parameter using Hspice-D V2012.03 after simulation?

Status
Not open for further replies.
A

Alex Liao

Member level 4
Member level 4
Joined
Apr 8, 2013
Messages
75
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,288
Visit site
Activity points
1,991
Based on my knowledge, I use Spectre simulator and after simulation, through Results=> Print Tab, I could print Model Parameter. While in Hspice is there a similar trick to do this? Any reply is appreciated.

Thanks,
Alex.
 

state .OP in simulation setup file, then check the .lis file?
 

Fei said:
state .OP in simulation setup file, then check the .lis file?
Click to expand...

Hi Fei, I have set up the op simulation in Analyses OP in ADE panel. I believe stating .OP in simulation setup functions similarly. But I do not know how to find this setup file. Also I searched through all my directory hierarchy and failed to find any .lis file. But luckily I find model parameters in hspice.out after any simulation. Does your suggestion still work? I would like to try you suggestion. If so please tell me in more detail how to state and how to find the .lis file. Thank you.

Regards,
Alex.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top