Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Ir2112 mosfet driver from microcontroller

Status
Not open for further replies.
M

mshh

Full Member level 6
Joined
May 30, 2010
Messages
349
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,296
Location
usa
Activity points
3,871
i used the attached circuit with atmega 8 to drive dc buck converter and it was working very well , then i increased the input voltage on the drain to 20v and the input current was 4 A (from a power supply ) suddenly the output on Ho of IR2112 was zero when i removed the converter the output on Ho was 7.6 v dc constant when the volt on drain Vd was 9.6 . and when i connected power resistor to the source of the mosfet Ho was zero ,did i lost the driver ?
also I noticed that when I increased Vd to 20 volt the output on IR2112( Ho) increased too ,the pwm was amplified to 25 v on the Mosfet gate how could the IRfz48 mosfet survive while Vgs from (10-20 v )?


[url=https://obrazki.elektroda.pl/6311705000_1393610196.png][/URL]
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top