Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

IR DVD remote control

Status
Not open for further replies.

madchen

Newbie level 3
Joined
Aug 27, 2009
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,302
gsm forum

Hi, I was trying to mimic a remote control using a microcontroller and an Infrared emitter. I've been trying to capture the specific remote control signals using an oscilloscope and an IR detector, and then outputting them on my emitter, but that hasn't been working so far.

I was wondering if anyone could offer any advice on this, it would be greatly appreciated.

Thanks!
 

irmimic

Hey thanks for the quick reply. Basically, I just need to build the transmitting part. The receiving unit will be a dvd player.
 

rentron ir circuits

this circuit wosks me well. output power is quite high and can be reduced. power supply = 4xAA battery
 

mimic remote control

Sorry, I'm not very good at reading circuit diagrams. There are three LED's in series right? But the rest I'm not too sure about. If you could explain it, that would be great.
 

infrared dvd player remote

Here is what you want

Code:
http://www.cesko.host.sk/girderplugin.htm

This displays the characters send by remote.

Nandhu
 

dvd player remote control explanation

codes transmitted from IR-controls is not standardized: every manufacturer have its own - although there exists quasi-standards ones
here is the explanation
Now you need to read the sent signal then save it on the pic of your new tx right?
check this IR mimic project
http://www.tauntek.com/irmimic-learning-ir-remote-control-transmitter.htm
good :http://digilander.libero.it/alfred7...hannel IR remote system with micro PIC 16F84
Hope these will help.
thank by pushing the helped me or pm the thanks
 

ir pic remote control

hey,
even im tring to make an IR mimic using a PIc microcontroller.
could some one help me with the code in "c"
thankq .
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top