Infrared Transmitter and Receiver

[trabzone]

multichannel infrared transmitter

I need a good infrared transmitter and receiver
How can i make a good transmitter and receiver?
All my trials are crashed.
Please help
Thanx

 

[flatulent]

receiver tk19 749

Here are some things to keep in mind.

1. Both emitter and detector shoul be rated at the same wave length and the detector should have a IR filter to keep response from ordinary light down.

2. Drive the emitter with the full rated current.

3. The amplifier following the detector should be of the transconductance type. Use an op amp with the + input to ground, a resistor from the output to the - input and the detector diode from the - input to a supply voltage. This should be oriented so that the diode is reverse biased.

4. There may be pick up of the light from artificial sources operating from the utility mains. Check for this in your receiver. Two ways to get around this is to use physical barriers to keep the lignts from shining directly on the detector. The other is to use a high pass filter (series capacitor) after the first amplifier stage and use a signaling scheme which does not have any low frequency components. One of these is to use FSK. Exar compnay makes many good ICs in this area.

 

[enigma460]

tk19 ir transmitter

Here is a site to look at:

**broken link removed**

http://www.commlinx.com.au/ir.htm

Have Fun

Enigma460

 

[trabzone]

thanx so much
i will try flatulent

 

[klug]

Also, do not forget to make electromagnetic shield on detector. It is very sensitive and afraids impulse interference.

 

[RegUser_2]

Try the HP HFBR-1402 TX/RX

 

[gyro]

If you need IR transceiver for your PC here is quite easy example

http://rcswww.urz.tu-dresden.de/~sb831436/irda/irda.htm

 

[Analyzer]

Hi,

If you like to build a multi channel ir receiver/transmitter try to use compliant ir devices.Try to look at www.novalog.com They have minisir transreceiver ic's.You can connect it to a mcu easily.If you need further info.Just ask.

Analyzer.

 

[se7en]

search for vishay

 

[Analyzer]

Hi,
You also can use normal ir transmitter leds and TK-19 from grundig.This ic is very common and you can find it easily.

Analyzer.