Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Increasing the ports speed of stm32f103

Status
Not open for further replies.

mohammad60

Newbie level 2
Joined
Sep 12, 2009
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
iran
Activity points
1,297
i want to increase speed of ports of st32f103 ?
i have 4mhz with set and reset of one pin?
but i want to receive 18mhz?
please help me
 

Re: stm32f103

Hello,

First , you need to configure the clock pll and then chose the correct value of the prescaler to provide to the gpio divice attached to the port.

Instructions regarding the commads to configure the clock you can find at stm.

And 18 Mhz?? Hum i think is not so high. I never tested.

If you need sample code, and the libraries, send email

Regards
 

Re: stm32f103

Hi

The STM32 DS says it can switch I/O as fast as 50MHz

But you have to configer the clock & PLL to work as fast as this micro can - 72MHz

All the best

Bobi

The microcontroller specialist
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top