Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

IN stm32 JTAG and UART connectivity

Status
Not open for further replies.
M

MD18

Junior Member level 3
Joined
Dec 9, 2021
Messages
29
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
166
Hello,

We working on custom board. We using this controller STM32745IIkx. In JTAG we connect the
USART1 port, but there is pin mapping issue, so **broken link removed** I am unable to use **broken link removed** instead of UASART1 can I use USART2.I am sharing its schematic THE VCP_TX and VCP_RX can I use USART2.Please guided me.



JTAG
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top