Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Image processing using camera by an image processor + MATLAB

Status
Not open for further replies.

nikhildascl

Full Member level 3
Joined
Apr 15, 2012
Messages
150
Helped
15
Reputation
30
Reaction score
14
Trophy points
1,318
Location
Kerala, India
Activity points
2,115
Hi friends, i am planning to do a project in image processing. I wish to do a real time project since doing the same in software is common. So, i decided to use a DSP processor and burn the MATLAB code to the processor. A camera interface will capture images and process according to the burned code. I need a video/ image output from the processor in any compatible format. But i don't have any idea about all these. I don't know which DSP i should select and also the camera. Waiting for a reply. Thanks in advance.
 

roshan12

Junior Member level 2
Joined
Dec 20, 2013
Messages
23
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
230
Try some object tracking papers in MATlab.
 

fun2design83

Newbie level 6
Joined
Aug 8, 2013
Messages
14
Helped
1
Reputation
2
Reaction score
1
Trophy points
3
Location
Calgary
Activity points
115
check this out
https://www.mathworks.com/hardware-support/raspberry-pi.html

When I was doing image processing, I did all algorithm test and implementation on MATLAB to just check the quality of the algorithm, output performance, and measuring the simplicity of the algorithm itself. and then I implemented everything on FPGA. I am not sure how efficient MATLAB's Library is, but my gut feel says it couldn't be amd you would see lack of performance if you go the combination of MATLAB ported code to DSP Microcontroller.
 

Donna111

Newbie level 4
Joined
Oct 18, 2013
Messages
6
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
35
Hi there
For me ,i usually do the image processing using an image processor.It supports to capture images and process according to the burned code.But you said that you need a video/ image output from the processor in any compatible format.That is a little bit strange for me.I am not so good at image processing.And it will be difficult for me if there is no image program.So why not you try an image program ?
They offer some tutorial for it.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top