Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronic Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

if place the component in the board get as overlap ,whether it can error or not?

Status
Not open for further replies.

akrishna71@gmail.com

Junior Member level 3
Joined
Oct 8, 2012
Messages
28
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,283
Location
CHENNAI,INDIA
Activity points
1,496
hi buddy's
i am using orcad software for pcb board designing, i have net listed the circuit , and while place the components getting overlap , because the board dimension is poor. so my doubt is whether if i place the component like this whether i get the error or not while apply the gerber ?


and one more thing dude , please tell me how to develop the circuit designing knowledge by or cad .,,.,...

how to improve my carrier in the pcb designer profession ,.? please tell me dude'zzzz
 
Last edited:

kabaleevisu

Advanced Member level 2
Joined
Apr 14, 2010
Messages
615
Helped
85
Reputation
170
Reaction score
81
Trophy points
1,308
Location
Chennai,India
Activity points
4,507
hi krishna,
please follow below i mention,
1.while placing the component set the grid first and place (major components 25mil,decoupling 5mil or 10 mils).in your design has major component like BGA,connector first place the component in 25mils grid and place other components like Resistor and capacitor etc.,.
2.while placing the component (assembly should not overlap )place bound top need to consider and DFM.
3.update knowledge in BGA routing,DDR and analog and digital boards.
 
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top