Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Identifying an Illuminated Rocker Switch

Status
Not open for further replies.

elektrotechnik

Junior Member level 1
Junior Member level 1
Joined
Jul 31, 2013
Messages
19
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Visit site
Activity points
198
Hi,

I am trying to identify the switch that I have found in a project box.

It is an illuminated rocker switch with 4 terminals, that I think is DPST.

It has an "N" corresponding to two terminals and a "1" and a "1." corresponding to the two other inputs as shown in the image.

Can someone help me identify this switch and what the pins are used for?

Thanks!

photo 2 (4).JPGphoto 1 (5).JPG
 

In the circuit where I got this part from,

Line was connected to "1"
Neutral was connected to the leftmost "N" terminal.
A wire connected from the "1." pin to a "NO" terminal on an SPDT Momentary Switch
A Wire connected from the other "N" terminal to a component that looked like a terminal block.

I'm not sure why it is configured this way. Any thoughts?
 

that I think is DPST
Unlikely, rather SPST. 1.-1 is the switch, N-N the indicator.

But you should be able to identify the circuit easily with a continuity tester or multimeter.
 

Unlikely, rather SPST. 1.-1 is the switch, N-N the indicator.

But you should be able to identify the circuit easily with a continuity tester or multimeter.

What do you mean by "1.-1 is the switch, N-N the indicator."?
 

Not a DPST but just a SPST with "1"

External 120V is required to operate the "N" neon which normal triggers <90V so 100V min if you want a reliable indication. The 100k current limit resistor would be internal and one "N" could be connected to the switched "1" thus requiring only the Neutral for the Neon indicator to the other "N"
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top