Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

ICSP jdm programming help

Status
Not open for further replies.
D

devil6600

Full Member level 5
Joined
Nov 15, 2008
Messages
250
Helped
7
Reputation
14
Reaction score
7
Trophy points
1,298
Activity points
2,931
hi
i have built a circuit which have pic16f877a tqfp and few 3v sensors. i forgot to program bootloader in the chip and have soldered it. now how can i program it? can i use jdm programmer to program it? i fear that using jdm may damage 3v sensors since pic+sensors have common power and ground lines. Is there a way i can program it without damaging the sensors? removing the pic is the only option?
thanks in advance
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top