ibm process subc element

[eng]

lvs subcx

Hi all,
I'm using IBM 0.18um process. In this process there is a subcx element which represents substrate connection. This element has 2 terminals in schematic one of them should be connected to ground pin and the other one is substrate itself. When layout is being drawn the sub pin comes as a diffent terminal. Can anyone tell me where to put this pin and which layer to assign it?

Thanks

 

[psmon]

LVS will be OK if the sub contact in the layout has the same name as the ground pin in the schematic.

 

[pinyan]

hello psmon
the name of sub contact in the layout?
i'm not very sure about that.where can i set its name?