shreyaskm
Newbie level 2

Hello,
I have a very basic question regarding the IBIS models and the way the simulator understands them.
I observe that the IBIS models have the V-I characteristics and the V-T waveforms to
reflect the way the buffers behave.
If we have a capacitive /transmission line load in my simulation set up, How will the simulator extrapolate the
Information from the resistive load scenario that we have captured in the V-T waveform.
Is there any document that I could get to read about? Or can you give a brief overview of how the simulator understands these models?
Best Regards,
Shreays
I have a very basic question regarding the IBIS models and the way the simulator understands them.
I observe that the IBIS models have the V-I characteristics and the V-T waveforms to
reflect the way the buffers behave.
If we have a capacitive /transmission line load in my simulation set up, How will the simulator extrapolate the
Information from the resistive load scenario that we have captured in the V-T waveform.
Is there any document that I could get to read about? Or can you give a brief overview of how the simulator understands these models?
Best Regards,
Shreays