Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

IBIS-AMI files for Xilinx Kintex7

Status
Not open for further replies.

soheyl

Member level 2
Joined
Nov 5, 2004
Messages
50
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Activity points
299
I want to simulate GTX buses of Xilinx Kintex7 in Cadance Allegro PCB SI tools; but I need IBIS-AMi files for it. Do you know from where I can find them for Kintex7 devices and is there any difference between using IBIS-AMI files and IBIS files in Allegro?

Thanks
 

Try Xilinx first...
Though most FPGA software will export an IBIS file complete with the drive currents you have set for your ports.
 

Try Xilinx first...
Though most FPGA software will export an IBIS file complete with the drive currents you have set for your ports.

On Xilinx website just IBIS files exists and these are not for GTXs.
 

I had the same problem with spartan6. then I had to contact Xilinx support, then they gave me the AMI models.
Normal ibis model and AMI model are totally different, they are not combined into one file.
 

As I said most FPGA compilers will spit out an IBIS file, try that, I have used these in preference to the generic files as the IO is preconfigured to the drive strength and pull up/downs catered for where applicable.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top